
WMOi3 Integrated modem 25/01/00
8
This confidential document is the property of WAVECOM and may not be copied without a written
authorization
The following table describes the electrical characteristics of the
interface.
Some signals require particular connections and are specified in bold
characters.
Pin # Name I/O I/O type Description Comment
1 GND GROUND High current
2 GND GROUND High current
3 +5V I Supply High current
4 +5V I Supply High current
5 CT109/DCD O CMOS/2X RS232-Data Carrier Detect
6 GND GROUND High current
7 GPIO2 I/O CMOS/2X General Purpose I/O
8 SPK2N O Analog Speaker2 negative output
9 CT125/RI O CMOS/2X RS232-Ring Indicator
10 SPK2P O Analog Speaker 2 positive output
11 GPIO1 I/O CMOS/2X General Purpose I/O
12 SPK1P O Analog Speaker 1 positive output
13 CT106/CTS O 1X RS232 interface Clear To
Send
14 SPK1N O Analog Speaker 1 negative output
15 ON/~OFF I Power ON/OFF control
16 MIC2P I Analog Microphone 2 positive input
17 AUXV0 I Analog Auxiliary ADC input
18 MIC2N I Analog Microphone 2 negative input
19 ~RST I Reset active low Open Collector
20 MIC1P I Analog Microphone 1 positive input
21 GND I Ground
22 MIC1N I Analog Microphone 1 negative input
23 BOOT I BOOT Open Collector
24 GND GROUND High current
25 CT103/TX I RS232 interface - Transmit Pull up to VCC
with 100K
ΩΩ
when
not used
26 GPIO0 I/O CMOS/2X General Purpose I/O See 3.2.3
27 CT107/DSR O 1X RS232 interface
Data Set Ready
28 CT104/RX O 1X RS232 interface – Receive
29 CT108-2/DTR I RS232 interface
Data Terminal Ready
Pull up to VCC
with 100K
ΩΩ
when
not used
30 CT105/RTS I RS232 interface
Request To Send
Pull up to VCC
with 100K
ΩΩ
when
not used
Kommentare zu diesen Handbüchern